General requirements.

Exposed moving parts such as gears, projecting screws, setscrews, chain, cables, chain sprockets, and reciprocating or rotating parts, which constitute a hazard, shall be guarded.

All controls used during the normal operation cycle shall be located within easy reach of the operator's station.

Electric motor operated hoists shall be provided with:

A device to disconnect all motors from the line upon power failure and not permit any motor to be restarted until the controller handle is brought to the "off" position;

Where applicable, an overspeed preventive device;

A means whereby remotely operated hoists stop when any control is ineffective.

All base-mounted drum hoists in use shall meet the applicable requirements for design, construction, installation, testing, inspection, maintenance, and operations, as prescribed by the manufacturer.

Specific requirements. [Reserved]

This section does not apply to base-mounted drum hoists used in conjunction with derricks. Base-mounted drum hoists used in conjunction with derricks must conform to §1926.1436(e).