ROSIN CORE SOLDER PYROLYSIS PRODUCTS (as FORMALDEHYDE)
CAS # | NO CAS |
---|---|
Formula |
CH₂O |
Synonyms |
Physical description | Colorless to white crystalline, odorless solid. | ||
---|---|---|---|
Boiling point | decomposes | Molecular weight | 309.1 |
Freezing point/melting point | 473°F (decomposes) | Vapor pressure | depends on specific constituents |
Flash point | Vapor density | ||
Specific gravity | 1.7 | Ionization potential | |
Lower explosive limit (LEL) | Upper explosive limit (UEL) | ||
NFPA health rating | NFPA fire rating | ||
NFPA reactivity rating | NFPA special instruction | ||
Vapor hazard ratio (VHR) | |||
Historical exceedance percentage | |||
Target organs |
Analyte code (IMIS no.) | 2227 | ||
---|---|---|---|
Sampling group | |||
Sampler/Sampling media | Coal Tar Pitch Volatiles (CTPV) Sampling Filters and Cassette [SLTC109] | ||
Sampling time* | 480 min |
||
Sampling volume (TWA)* | 960 L |
||
Sampling flow rate (TWA)* | 2 L/min |
||
Sampling volume (STEL/Peak/C)* |
|
||
Sampling flow rate (STEL/Peak/C)* |
|
||
Analytical method instruments | HPLC | ||
Method reference | OSHA 58 (validated in conjunction with Coal Tar Pitch Volatiles and Coke Oven Emissions) | ||
Notes | After sampling, filter must be transferred to a vial with a Teflon-lined cap. Sample must be protected from direct sunlight. |
||
Special requirements | These media are prepared by SLTC as needed and are not available for immediate shipment. Please allow time for SLTC to prepare these media prior to sampling. |
* All sampling instructions above are recommended guidelines for OSHA Compliance Safety and Health Officers (CSHOs), please see the corresponding OSHA method reference for complete details.
Wipe Sampler/Sampling media | |
---|---|
Bulk Method |
Device | |||||
---|---|---|---|---|---|
Model/Type | |||||
Sampling information (see manufacturer instructions) |
OSHA PEL
8-hour TWA (ST) STEL (C) Ceiling Peak |
NIOSH REL
Up to 10-hour TWA (ST) STEL (C) Ceiling |
ACGIH TLV©
8-hour TWA (ST) STEL (C) Ceiling |
|||||
---|---|---|---|---|---|---|---|
PEL-TWA | REL-TWA |
0.1 mg/m³ |
TLV-TWA |
Exposure by all routes should be carefully controlled to levels as low as possible. [1992] |
PEL-TWA |
0.1 mg/m³ |
|
PEL-STEL | REL-STEL | TLV-STEL | PEL-STEL | ||||
PEL-C | REL-C | TLV-C | PEL-C | ||||
Skin notation |
NA |
Skin notation |
N |
Skin notation |
N |
Skin notation |
N |
Notes:
Not established |
Notes:
Ca in the presence of formaldehyde, acetaldehyde, or malonaldehyde. REDUCE EXPOSURE TO LOWEST FEASIBLE CONCENTRATION. See Appendix A, NIOSH Potential Occupational Carcinogens and Appendix C, Supplementary Exposure Limits (Aldehydes). |
Notes:
dermal sensitization (DSEN), respiratory sensitization (RSEN) |
Notes: | ||||
Health factors: See NIH-NLM PubChem. | IDLH | ||||||
Carcinogenic classifications: NIOSH-Ca (in presence of aldehydes noted) |
Notes:
Ca |
||||||
AIHA emergency response planning guidelines - ERPG-1/ERPG-2/ERPG-3: |
Additional Resources and Literature References
NOAA: CAMEO Chemicals - Not listed NIOSH: Pocket Guide to Chemical Hazards - Rosin core solder, pyrolysis products (as formaldehyde) Literature References
|
Last Updated Date : 01/29/2021