• Record Type:
    OSHA Notice
  • Current Directive Number:
    08-06 (CPL 02)
  • Old Directive Number:
    08-06 (CPL 02)
  • Title:
    Cancellation of CPL 02-02-019 (CPL 2-2.19) Quality Control Weighing Program
  • Information Date:
Archive Notice - OSHA Archive

NOTICE: This is an OSHA Archive Document, and may no longer represent OSHA Policy. It is presented here as historical content, for research and review purposes only.

OSHA NOTICE
DIRECTIVE NUMBER: 08-06 (CPL 02) EFFECTIVE DATE: 8/6/08
SUBJECT: Cancellation of CPL 02-02-019 (CPL 2-2.19) Quality Control Weighing Program


ABSTRACT

Purpose: This notice cancels OSHA Instruction CPL 02-02-019, Quality Control Weighing Program, 10/30/1978.

Scope: OSHA-wide.

References: None.

Cancellations: CPL 02-02-019, Quality Control Weighing Program, 10/30/1978.

State Impact: This notice describes a Federal Program Change which does not require State adoption.

Action Offices: OSHA Regional Offices, Area Offices and Salt Lake Technical Center

Originating Office: Directorate of Science, Technology and Medicine

Contact: Salt Lake Technical Center
Directorate of Science, Technology and Medicine
8660 Sandy Parkway
Sandy, UT 84070


By and Under the Authority of

Edwin G. Foulke, Jr.
Assistant Secretary





Executive Summary

This notice cancels OSHA Instruction CPL 02-02-019, Quality Control Weighing Program, 10/30/1978.

Significant Changes

OSHA Instruction CPL 02-02-019, Quality Control Weighing Program, 10/30/1978, is cancelled. This instruction describes a weighing program that is obsolete.





  1. Purpose. This notice cancels OSHA Instruction CPL 02-02-019, Quality Control Weighing Program, 10/30/1978. The weighing program is obsolete and has been replaced by laboratory analysis at the Salt Lake Technical Center in accordance with OSHA Method PV2121 (Gravimetric Determination).

  2. Scope. This notice applies OSHA-wide.

  3. Cancellation. OSHA Instruction CPL 02-02-019, Quality Control Weighing Program, 10/30/1978.

  4. Significant Changes. OSHA Instruction CPL 02-02-019, Quality Control Weighing Program, 10/30/1978, is cancelled.

  5. References. None.

  6. Expiration Date. One year after the date of issuance.

  7. Action.

    1. Responsible Office. Salt Lake Technical Center

    2. Action Offices. Salt Lake Technical Center, Regional and Area Offices

    3. Information Offices. Compliance assistance, consultation

  8. Federal Program Change. This notice, which cancels an obsolete directive, describes a Federal program change for which State adoption is not required. State plans should assure that proper laboratory procedures are being used in their program.