Ultratec Special Effects, Inc. | Occupational Safety and Health Administration osha.gov

Violation Detail

Standard Cited: 19100119 L04 Process safety management of highly hazardous chemicals.

Inspection Nr: 1095917.015

Citation: 01001D

Citation Type: Serious

Abatement Date: 03/30/2017 2

Initial Penalty: $5,390.00

Current Penalty: $0.00

Issuance Date: 03/15/2016

Nr Instances: 3

Nr Exposed: 6

Related Event Code (REC):

Gravity: 10

Report ID: 0418300

Contest Date: 04/08/2016

Final Order: 12/30/2016

Emphasis:

**Penalty and Failure to Abate Event History**
Type	Latest Event	Event Date	Penalty	Abatement Due Date	Citation Type
Penalty	J: ALJ Decision	12/30/2016	$0.00	03/30/2017	Serious
Penalty	C: Contested	04/14/2016	$5,390.00	04/29/2016	Serious
Penalty	Z: Issued	03/15/2016	$5,390.00	04/29/2016	Serious

Text For Citation: 01 Item/Group: 001D Hazard:

29 CFR 1910.119(l)(4): Process safety information required by paragraph (d) of this section was not updated when a change covered by this paragraph resulted in a change in the process safety information: (a) On or about 10/06/2015 - at West Side Building A14, Management of Change (MOC) identified as "Facility Addition A14 " dated June 2015 addressed refurbishing and putting into operation process building A14 and process safety information was not updated and available for the Hobart chopper, ventilation fan, scales, humidity/temperature gauge, interlocks, electrostatic discharge system (ESD), and relief system (blow-out walls and clamps). (b) On or about 10/06/2015 - at West Side Building A6, MOC identified as "3" (inch) Comet press installed in A6" dated Sept 18, 2015 addressed movement and installation of 3" press in A6 and process safety information was not updated and available for the Comet Press, Comet ejector tool, and ESD. (c) On or about 10/06/2015 - at West Side Building A4, MOC identified as "Process Change" dated May 2015 addressed Tracer Process Redesign and process safety information was not updated and available for the Tracer plates, Tracer ejector tool, ventilation fan and ESD.

Thank You for Visiting Our Website

You are exiting the Department of Labor's Web server.

The Department of Labor does not endorse, takes no responsibility for, and exercises no control over the linked organization or its views, or contents, nor does it vouch for the accuracy or accessibility of the information contained on the destination server. The Department of Labor also cannot authorize the use of copyrighted materials contained in linked Web sites. Users must request such authorization from the sponsor of the linked Web site. Thank you for visiting our site. Please click the button below to continue.