Translate
Violation Detail
Standard Cited: 19100212 A01 General requirements for all machines.
Inspection Nr: 1371884.015
Citation: 01003
Citation Type: Serious
Abatement Date: 07/29/2019 2
Initial Penalty: $13,260.00
Current Penalty: $7,956.00
Issuance Date: 06/21/2019
Nr Instances: 8
Nr Exposed: 24
Related Event Code (REC):
Gravity: 10
Report ID: 0521100
Contest Date:
Final Order: 07/10/2019
Emphasis:
| Type | Latest Event | Event Date | Penalty | Abatement Due Date | Citation Type | Failure to Abate Inspection |
|---|---|---|---|---|---|---|
| Penalty | I: Informal Settlement | 07/10/2019 | $7,956.00 | 07/29/2019 | Serious | |
| Penalty | Z: Issued | 06/21/2019 | $13,260.00 | 07/29/2019 | Serious |
Text For Citation: 01 Item/Group: 003 Hazard:
29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks: a) On or about 1/17/2019, the Pouch machine out feed belt conveyor had an ingoing nip point below the roller for HMC #4. b) On or about 1/17/2019, the Roan machine cut off roll was not guarded adequately from aisle side with a nip point on the sealing roll. c) On or about 1/17/2019, the #6 Coater wax finish ingoing nip points were not protected from access for the op rubber roll and bottom cylinder roll. d) On or about 1/18/2019, the Former slitter room machine #2 had unguarded ingoing nip points. e) On or about 1/18/2019, There were unguarded slitters on the REM Slitter, FRS #2. f) On or about 1/22/2019, there was a lack of guarding on the former section for the thermo former #7 which left access to pinch points inside the machine in three areas. g) On or about 1/22/2019, Lack of guarding for #7 thermo trim press T-130 with machine mounted approximately 29" off the floor. h) On or about 1/22/2019, the #19 Treater platform had pinch points as the machine rotated over the guard rails provided.