1
06/06/2024 - 1910.179(n)(3)(vi) - Cranes and the use of protective helmets
2
06/29/2015 - 1910.179(g) - Covering for Grounded Contact Conductors on Overhead Traveling Crane Systems (Patrick E. Wall/DEP/GIE/Harvey/26611)
3
06/29/2015 - 1910.179(g)(1)(i) - Covering for Grounded Contact Conductors on Overhead Traveling Crane Systems (Patrick E. Wall/DEP/GIE/Harvey/26611)
4
09/13/2013
- 1910.179 -
Overhead Crane operations
5
12/05/2011
- 1910.179 -
Electrical Grounding of Overhead Cranes and Hoists.
6
03/30/2010 - 1910.179(i) - Clarification on whether a visual rotating beacon or strobe light is an acceptable warning signal on a radio operated crane.
7
03/30/2010
- 1910.179, 1910.179(i) -
Clarification on whether a visual rotating beacon or strobe light is an acceptable warning signal on a radio operated crane.
8
08/28/2009 - 1910.179(k) - Requirements for rated load tests for new or altered cranes.
9
08/28/2009 - 1910.179(b) - Requirements for rated load tests for new or altered cranes.
10
08/28/2009
- 1910.179, 1910.179(b), 1910.179(k) -
Requirements for rated load tests for new or altered cranes.
11
11/16/2007 - 1910.179(n)(3)(vi) - Whether crane lifting devices are considered to be part of the load and are allowed to be hoisted over personnel.
12
11/16/2007
- 1910.179, 1910.179(n)(3)(vi) -
Whether crane lifting devices are considered to be part of the load and are allowed to be hoisted over personnel.
13
04/25/2006 - 1910.179(h)(2)(iii)(a) - Use of lower-limit device that stops lower hook travel with at least two wraps remaining on the drum.
14
04/25/2006
- 1910.179, 1910.179(h)(2)(iii)(a) -
Use of lower-limit device that stops lower hook travel with at least two wraps remaining on the drum.
15
11/15/2005 - 1910.179(f)(1)(ii) - A worm drive gearbox is not considered to be a holding brake.
16
11/15/2005 - 1910.179(f)(1)(i) - A worm drive gearbox is not considered to be a holding brake.
17
11/15/2005 - 1910.179(a)(2) - A worm drive gearbox is not considered to be a holding brake.
18
11/15/2005
- 1910.179, 1910.179(a)(2), 1910.179(f)(1)(i), 1910.179(f)(1)(ii) -
A worm drive gearbox is not considered to be a holding brake.
19
11/03/2005 - 1910.179(h)(2)(iii)(a) - Definition of "extreme low position" for overhead and gantry cranes.
20
11/03/2005
- 1910.179, 1910.179(h)(2)(iii)(a) -
Definition of "extreme low position" for overhead and gantry cranes.
21
10/06/2004 - 1910.179(n)(2)(ii) - Loads must be attached to the block hook by a sling or other approved device and may not be attached directly to the running rope.
22
10/06/2004 - 1910.179(n)(2)(i) - Loads must be attached to the block hook by a sling or other approved device and may not be attached directly to the running rope.
23
10/06/2004
- 1910.179, 1910.179(n)(2)(i), 1910.179(n)(2)(ii) -
Loads must be attached to the block hook by a sling or other approved device and may not be attached directly to the running rope.
24
01/16/2004
- 1910.179 -
Standards applicable to an automatic transfer device for processing and moving product.
25
10/21/2003 - 1910.179(n)(4) - Testing of hoist limit switches.
26
10/21/2003 - 1910.179(k)(1)(ii) - Testing of hoist limit switches.
27
10/21/2003
- 1910.179, 1910.179(k)(1)(ii), 1910.179(n)(4) -
Testing of hoist limit switches.
28
08/28/2003 - 1910.179(j)(3) - Clarification of Overhead and Gantry Cranes definition of "complete inspection" and "periodic inspection" requirements.
29
08/28/2003 - 1910.179(j)(1) - Clarification of Overhead and Gantry Cranes definition of "complete inspection" and "periodic inspection" requirements.
30
08/28/2003
- 1910.179, 1910.179(j)(1), 1910.179(j)(3) -
Clarification of Overhead and Gantry Cranes definition of "complete inspection" and "periodic inspection" requirements.
31
06/26/2002
- 1910.179 -
Requirements for crucibles and other below-the-hook lifting devices.
32
04/06/2001 - 1910.179(b)(6)(i) - Two-inch clearance must be maintained for overhead bridge cranes.
33
01/11/2001
- 1910.179 -
Acceptable use of load-limiting clutches as upper and/or lower limit devices.
34
11/08/1999 - 1910.179(b)(8) - Training for travel lift (mobile gantry crane) operators.
35
11/08/1999 - 1910.179(a)(35) - Training for travel lift (mobile gantry crane) operators.
36
03/24/1999 - 1910.179(n)(3)(vi) - Operators of overhead and gantry cranes must not carry loads over people.
37
02/25/1998 - 1910.179(b)(5) - Rated load markings for overhead bridge and gantry cranes.
38
10/21/1997
- 1910.179 -
Inspection certification record requirements in overhead and gantry cranes.
39
01/03/1997
- 1910.179 -
Clarification of overhead and gantry cranes.
40
11/08/1996
- 1910.179 -
Holding brake requirements on overhead cranes.
41
09/26/1996
- 1910.179 -
Interpretation of the overhead and gantry cranes standard.
42
09/18/1995
- 1910.179 -
Comments on Variance Application Number 2293.
43
08/08/1994
- 1910.179 -
A crane may be used for rated load testing of below-the-hook lifting device provided the test does not exceed 125% for the crane's rated load.
44
11/29/1993
- 1910.179 -
Hoists that have two upper "hoist limit switches".
45
11/02/1993 - 1910.179(b)(2) - Load testing of underhung trolleys/lifting devices.
46
06/25/1993 - 1910.179(d) - Guidelines for platforms and walkways on cranes.
47
06/25/1993 - 1910.179(b) - Guidelines for platforms and walkways on cranes.
48
04/06/1993
- 1910.179 -
Use of overhead bridge and gantry cranes as work platforms.
49
03/27/1992
- 1910.179 -
Inspection of running ropes.
50
02/27/1992
- 1910.179 -
The need for an employer to comply with standards other than those which are enforced by OSHA.
51
02/12/1992
- 1910.179 -
Inspection of Crane Hooks.
52
10/08/1991
- 1910.179 -
Application of bridge brakes.
53
03/04/1991
- 1910.179 -
Clarification of OSHA standard on Overhead and Gantry Cranes
54
03/08/1990 - 1910.179(n)(3)(vi) - An engine overhaul work station being developed.
55
01/03/1989 - 1910.179(k)(2) - "Rated Load Test" for cranes as specified at 1910.179(k)(2).
56
04/23/1984
- 1910.179 -
Interpretation of 1910.179, Overhead and Gantry Cranes
57
03/07/1983 - 1910.179(b)(2) - Clarification on physical qualifications for crane operators.
58
07/01/1982
- 1910.179 -
OSHA's position that the main or emergency switches must be capable of being locked out.
59
04/23/1979
- 1910.179 -
The design of trolley bumpers for electric overhead traveling cranes.
60
03/08/1977
- 1910.179 -
Wind Indicators and Rail Clamps.
61
01/04/1977
- 1910.179 -
Overhead and Gantry Cranes.
62
03/26/1976 - 1910.179(h)(2)(i) - Clarification on OSHA requirements for hoist cables on cranes.
63
03/02/1976 - 1910.179(b)(4) - 1910.179(b)(4) only applies to outdoor storage bridge gantry cranes with spans over 100ft.
64
10/23/1975 - 1910.179(e)(3) - Definition of slow rate of speed for crane bridges and trolleys.
65
10/23/1975 - 1910.179(e)(2) - Definition of slow rate of speed for crane bridges and trolleys.
66
09/29/1975 - 1910.179(e)(3) - Applicability of bridge and trolley bumper requirements.
67
09/29/1975 - 1910.179(e)(2) - Applicability of bridge and trolley bumper requirements.
68
08/27/1975 - 1910.179(b)(2) - Clarification on using an overhead crane beyond its rated load.
69
08/25/1975 - 1910.179(n)(3)(x) - Crane operator's responsibility during hand banding operations.